2016 Audi RS6 (c7 facelift) installed with a removable towbar and electric socket suitable for cycle carriers using a Audi Dedicated wiring kit. This RS6 already had the removable towing panel built into the lower rear bumper diffuser. This simply pops of when you want to tow.
You must check your RS6 has been homologated to tow by Audi, see the last two pictures. If it hasn’t the 2nd line of weights will be empty.
2021 BMW 118 M-Sport with the M-Performance bodykit (f40 chassis) installed with a Witter removable Swan Neck towbar and BMW vehicle specific and dedicated wiring loom. Once hooked up the vehicle will enter ‘towing mode’ which will certain characteristics on the vehicle. Bulb monitoring on the trailer/caravan, rear pdc auto cut-off, rear fog light auto off, trailer stability enabled, auto hold handbrake adjusted.
2020 Range Rover Evoque L551 (mk2 model) installed with a removable Tow-Trust towbar and Land Rover dedicated wiring kit (vehicle specific). This towbar design only required a modification to the underside of the original central lower bumper panel, this can only be seen if you are under the vehicle. The 13pin electrical socket swivels up under the bumper when not in use.
Installation time is 4 hours at our workshop in Bristol.
2021 Volkswagen Touareg R Line installed with a detachable towbar and 13pin Vw dedicated electrics for caravan towing. The integrated CANbus tow bar wiring will give interactive function whilst towing, auto handbrake adjust, bulb monitoring, PDC cut-off, electronic stability settings modified, auto tailgate disabled. We have used the Tow Trust removable towbar including a swivel mounted towing socket which cant be seen unless underneath the car.
2021 face lifted Audi RS4 Avant having a removable tow bar installed. We have used a detachable Tow-Trust towbar and 13pin Audi dedicated (vehicle specific) wiring which we code in-house to the vehicle. We have cut a section from the lower carbon fibre bumper trim (this is on the underside so can not be seen).
Notes:
- Your vehicle must have a towing capacity stamped on its VIN plate (located on drivers side lower A-Pillar, near door hinge)
- If your RS4 has DRC (dynamic ride control) then we cannot install this or any other towbar
- Installation takes around 4 hours at our workshop in Bristol, England, UK
